Emergency Water Damage Restoration
This is the call for water that's coming in right now. We get a local specialist on the way to stop the source, pull the water out and start drying the same day.
Call Now: (888) 596-0163Water Damage Restoration in Arlington, TX
A leak at 2 a.m. doesn't wait for business hours, and neither do we. If water's getting into your home or business in Arlington, Texas, call and we'll line up a nearby specialist who brings the extraction gear and dehumidifiers to deal with it properly.
Call Now: (888) 596-0163Someone picks up, day or night.
What we know about water in Arlington
Tarrant County, Texas. Public records, linked in each box.- Source: ACS 2023 5-year, table B25035
- 1985The middle year for homes around Arlington. Half are older
Homes around Arlington are newer than in 75% of the 28,807 places we track, which changes what tends to go wrong more than whether it does.
- Source: NOAA 1991-2020 Climate Normals, station USW00053907
- 36.2 inRain and melted snow, in inches, in a typical year
Arlington gets less than 66% of the 30,291 places on our list. Low totals can fool you. Roofs and drains get little practice here, so problems tend to show up all at once in the one big storm.
- Source: NOAA 1991-2020 Climate Normals, station USW00053907
- OCTOn average, the most rain and snow falls in October
Check your drains and the slope around the house ahead of October. It takes an afternoon, and it can save a lot of drying later.
- Source: OpenFEMA Disaster Declarations Summaries v2, 2016-01-01 to 2026-10-31
- 4Weather or water disasters out of 7 federal declarations for Tarrant County since 2016
- Hurricane2
- Severe Ice Storm2
No one kind of weather leads the list here. Whatever brings the water in, the first job is the same: stop it, then start drying. That leaves out 3 for causes such as fire or the pandemic.
Before anyone arrives
What to do right now in Arlington
You don't have to do all of this. Do what's safe, in this order, and leave the rest.
Shut off the water
Look for the main valve near the meter or where the line comes into the house, and turn it slowly, since older valves can stick. If it's one fixture, its own shutoff valve will do.
Stay clear of the power
If you can reach the breaker panel without stepping in water, switch off the wet rooms. If you can't, leave it alone, stay out of the water and tell us when you call.
Take pictures first
Before you clean up, photograph the water, where it came from and whatever it damaged. Your insurance company will ask, and you only get one chance at those shots.
Rescue what you can
Move rugs, papers, photos and electronics to a dry room, and prop furniture up off the wet floor. Everything else can wait.
Let the air move
If the water is clean and the power's safe, open interior doors and run the fans you have. Stay out if it's sewage or floodwater, and keep that air away from the rest of the house.
Call Now: (888) 596-0163
You've got about 24 to 48 hours to start drying before rot and mold become the bigger problem.
Typical build year
What tends to fail in Arlington houses like yours
Your home is too new for rusted steel pipe, but it may be just the right age for polybutylene, the gray plastic line used in many houses until the mid 1990s. It doesn't give much warning before it lets go.
The other usual suspects in a house this age are the second or third water heater, the supply lines under the toilets and the ice maker line behind the fridge. All of them are cheap to replace and expensive to ignore.
Call Now: (888) 596-0163
Help for every kind of water problem in Arlington
Water Damage Cleanup & Extraction
The more water that comes out at this stage, the less has to be dried later. Pumps and extraction units clear carpet, pad, hardwood and tile, then everything the water touched gets cleaned.
Call Now: (888) 596-0163
Flood Damage Restoration
Floodwater is never clean. It carries soil and sewage, so mud and silt get cleared, soaked drywall and insulation get cut out, and what stays gets disinfected.
Call Now: (888) 596-0163
Basement Water Damage Restoration
If your home has a basement, a failed sump pump or a backed-up drain can fill it fast. It gets pumped out, the concrete and block get dried, and someone finds out how the water got in.
Call Now: (888) 596-0163
Structural Drying and Dehumidification
Air movers and dehumidifiers run until the meters say your walls, subfloor and framing are back to normal. Not until they look dry. Until the readings prove it.
Call Now: (888) 596-0163
Water Damage Repair and Restoration
Once the structure is dry, the drywall, flooring, trim and paint go back. You'll have photos and notes for your claim along the way.
Call Now: (888) 596-0163The southern plains
Why water behaves differently in Arlington
Weather
Spring storms here don't mess around. Hail cracks shingles and skylights, and the rain can come faster than the gutters can take it. You might not see the leak until days later, on a ceiling two rooms away from the actual damage. A hard freeze is rarer, but when one lasts a day or two it splits pipes that were never protected for it.
Buildings
Houses here were built with the heat in mind more than the water. Carpet over concrete wicks up a leak fast. HVAC units and water heaters often sit in the attic, right over your living room. And if your home's on a slab, a leak underneath may only show as damp carpet along one wall, or as baseboards starting to swell.
Ground
Clay soil swells when it's wet and shrinks when it's dry. Over the years, that movement can crack a slab and the pipes beneath it. It also sheds hard rain instead of soaking it up, and that water has to go somewhere, often toward your garage or back door.
Drying
Water under a slab rarely shows on top. Acoustic equipment listens for the break in the line, thermal imaging maps the wet area, and drying then goes after the carpet, pad and bottom plates above it. It saves a lot of demolition.
When you call
How a Arlington water job goes after you call
We'll ask where you are, what happened and whether the water's still running. That takes a couple of minutes. Then we'll connect you with a specialist from our network who works in Tarrant County, and you can ask them when they can be there before you hang up. Homes and commercial buildings are both fine.
Expect a walk through the house with a thermal camera and a moisture meter, because what you can see is usually only part of it. The specialist will also tell you which of the three categories you've got. Category 1 water is clean, Category 2 is dirty, and Category 3 is sewage or floodwater. That last one changes the job, with plastic containment around the work area and negative air machines pushing air through HEPA filters.
Most of the job is drying, and it's slower than people expect. Extraction units, often truck-mounted, take out the bulk water. Air movers and low grain refrigerant (LGR) dehumidifiers then do the long, loud work of pulling moisture out of walls and floors. Desiccant units come in when it's too cold or the materials are too dense for LGR machines. Psychrometric readings, which are daily checks of temperature and humidity, tell the specialist if the setup needs changing.
A wall can feel dry and still hold plenty of water. That's why the specialist measures a dry standard from unaffected wood and drywall nearby and keeps the equipment running until the wet areas match. This is the method in the IICRC S500 standard, and those moisture logs back up your insurance claim.
What comes out and what stays in a Arlington home
More than you'd think, if it's caught early. Carpet soaked with clean water can often be dried in place once the pad's been pulled. Hardwood is worth trying to save too, with floor drying mats and slow drying, though it may need refinishing. Drywall that's wet only at the base can be cut a little above the waterline instead of being replaced to the ceiling, which is what a flood cut is.
Things change when the water's dirty. Anything soft that sewage or floodwater reached, such as carpet, pad and insulation, gets thrown out. Hard surfaces get cleaned and treated. Have a professional look at any gas appliance that got wet before you turn it back on, and don't walk on a floor that's gone spongy.
Where we take calls around Arlington
Calls come to us from homeowners, landlords and business owners across Arlington and Tarrant County. Give us your address, and we'll find out who's closest.
ZIP codes in Arlington
- 76011
- 76005
- 76001
- 76002
- 76006
- 76018
- 76013
- 76012
- 76010
- 76017
Arlington water damage questions
How fast can someone get to me in Arlington?
It depends on the time and the weather, but same-day help is what we aim for, and it's often a matter of hours. The local specialist will give you a time on the phone, so you're not left guessing.
Can I clean up water damage myself?
You can handle a minor spill if it's clean water and it hasn't gone anywhere. For anything that's reached the carpet pad, the walls or the floor below, professional drying really does make a difference, and floodwater or sewage should be left to people with the right protective gear.
How long does it take to dry out a house?
Most homes take three to five days of drying once the water's out. Dense materials such as hardwood and plaster can take longer, and any rebuilding comes afterward.
Can wet hardwood floors and carpet be saved?
Usually, with clean water and a fast start. Drying mats sit on hardwood and draw the moisture out slowly so the boards don't split. Sanding and refinishing can fix any cupping that's left. Carpet needs a new pad, and it can't be saved at all after sewage or floodwater.
Will my insurance pay for water damage?
Often, but not always. Insurers tend to pay for sudden leaks and not for long-term seepage. Flooding from outside needs its own policy. Call your insurance company early, and keep the moisture logs and photos, since they make the claim much easier.
Get help in Arlington now
(888) 596-0163Day or night, someone picks up. We'll connect you with a specialist who works in Tarrant County.