Basement Water Damage Restoration
Basements flood from below as often as from above. A failed sump pump, a backed-up floor drain, a leaking water heater or groundwater pushing through the walls can all leave water in the lowest part of your house. This job covers pumping it out, drying the concrete and block, and working out how the water got in, so it doesn't happen again next month.
Call Now: (888) 596-0163Someone picks up, day or night.
Drying concrete and block in below-grade rooms
Concrete and block hold on to water far longer than drywall does, and basements are often damp before anything floods. The industry standard, the IICRC S500, puts wet slabs and block walls in Class 4, which just means dense materials that need more time and drier air. What kind of water it was still matters too. A sewer backup through a floor drain counts as contaminated, and that changes what has to come out.
- Pumps that take the water right down to the slab
- Desiccant dehumidifiers, which keep working in cool basements where ordinary ones slow down
- Moisture meters that can read concrete, block and the bottom of the walls
- Thermal cameras to find where water's getting in through walls, cracks and the edge of the floor
- Air movers aimed low, across the slab and the bottom of finished walls
How a wet basement gets dried out
-
Pump it out
The standing water gets pumped down to the slab. If the sump pump failed, they'll check the float, the check valve and the discharge line, so the basement doesn't fill up again.
-
Find the entry point
They'll look at the water heater, supply lines, floor drains, window wells and any cracks in the walls. Water seeping in where the wall meets the floor usually means groundwater pushing in from outside, not a plumbing leak.
-
Remove and treat
Wet carpet, pad, insulation and the bottom of finished walls come out as needed. If the water came from a sewer backup, everything it touched gets cleaned and treated with antimicrobial.
-
Dry concrete and block
Dehumidifiers run with fans aimed at the slab and block walls. Readings get taken every visit, because concrete can feel dry on top while it's still holding water underneath.
Basement flooding questions
What should I do to clean up after my basement floods?
Stay out of the water until the power to the basement is off, since outlets and appliances sit low. Find the source if you can, such as a stopped sump pump or a leaking water heater. Take photos, move what you can to higher ground, then call (888) 596-0163 for pump-out and drying.
Who should I call for basement flooding?
For the water itself, call a water damage restoration company that can pump out, remove wet materials and dry the space. If the sump pump failed or a drain backed up, you may need a plumber too. Call (888) 596-0163, and we'll connect you with a local specialist.
How much does it cost to clean up a flooded basement?
It depends on how deep the water is, if the basement is finished, and whether it was clean water or a sewer backup. An unfinished basement with clean water is a much simpler job than a finished one with carpet, drywall and sewage. A specialist can tell you more after taking moisture readings.
Will homeowners insurance cover a flooded basement?
It depends on where the water came from. A burst pipe or failed water heater is usually covered. Groundwater seepage and outside flooding usually aren't, and sewer or sump pump backup is often covered only with an added endorsement, so it's worth reading your policy.
Why does water come up through my basement floor?
When the ground around your house gets soaked, the water pushes against the slab and the walls. Builders call it hydrostatic pressure, and it forces water through cracks and the joint where the wall meets the floor. A working sump pump and good drainage outside are the usual fixes.
Water in your basement?
(888) 596-0163Call (888) 596-0163, and we'll connect you with local specialists who can pump out the basement, dry it and find where the water came in.