Emergency Water Damage Restoration
This is the call for water that's coming in right now. We get a local specialist on the way to stop the source, pull the water out and start drying the same day.
Call Now: (888) 596-0163Water in the house? Call now, and we'll find you a local specialist.
Water where it shouldn't be gets stressful fast, and it keeps spreading while you work out what to do. If it's a burst pipe, a soaked ceiling or storm water at the door in Helena Valley Northeast, Montana, call us. We'll get a specialist from our network of local restoration companies moving toward you, with extraction equipment and dehumidifiers.
Call Now: (888) 596-0163Someone picks up, day or night.
Homes around Helena Valley Northeast are newer than in 90% of the 28,807 places we track, which changes what tends to go wrong more than whether it does.
That's drier than 96% of the 30,291 places we track. Low totals can fool you. Roofs and drains get little practice here, so problems tend to show up all at once in the one big storm.
Check your drains and the slope around the house ahead of June. It takes an afternoon, and it can save a lot of drying later.
No one kind of weather leads the list here. Whatever brings the water in, the first job is the same: stop it, then start drying. That leaves out 9 for causes such as fire or the pandemic.
Before anyone arrives
You don't have to do all of this. Do what's safe, in this order, and leave the rest.
Look for the main valve near the meter or where the line comes into the house, and turn it slowly, since older valves can stick. If it's one fixture, its own shutoff valve will do.
If you can reach the breaker panel without stepping in water, switch off the wet rooms. If you can't, leave it alone, stay out of the water and tell us when you call.
Before you clean up, photograph the water, where it came from and whatever it damaged. Your insurance company will ask, and you only get one chance at those shots.
Move rugs, papers, photos and electronics to a dry room, and prop furniture up off the wet floor. Everything else can wait.
If the water is clean and the power's safe, open interior doors and run the fans you have. Stay out if it's sewage or floodwater, and keep that air away from the rest of the house.
You've got about 24 to 48 hours to start drying before rot and mold become the bigger problem.
Typical build year
If your house dates from the late 1970s to the mid 1990s, take a look at the pipes. Polybutylene went into a lot of homes in those years. It's gray plastic, and it has a habit of failing with no warning. You can often spot it at the water heater or under a sink.
Then there's the water heater itself. Most tanks last 8 to 12 years, so a house this age is probably on its second or third, and yours may be getting close. If you see polybutylene, it's worth asking a plumber about it, even if nothing's leaking yet.
Call Now: (888) 596-0163
This is the call for water that's coming in right now. We get a local specialist on the way to stop the source, pull the water out and start drying the same day.
Call Now: (888) 596-0163
The more water that comes out at this stage, the less has to be dried later. Pumps and extraction units clear carpet, pad, hardwood and tile, then everything the water touched gets cleaned.
Call Now: (888) 596-0163
Floodwater is never clean. It carries soil and sewage, so mud and silt get cleared, soaked drywall and insulation get cut out, and what stays gets disinfected.
Call Now: (888) 596-0163
If your home has a basement, a failed sump pump or a backed-up drain can fill it fast. It gets pumped out, the concrete and block get dried, and someone finds out how the water got in.
Call Now: (888) 596-0163
Air movers and dehumidifiers run until the meters say your walls, subfloor and framing are back to normal. Not until they look dry. Until the readings prove it.
Call Now: (888) 596-0163
Once the structure is dry, the drywall, flooring, trim and paint go back. You'll have photos and notes for your claim along the way.
Call Now: (888) 596-0163The mountains and high plains
If you've lived through a few winters here, you know the pattern. It's the deep cold that splits the pipe, and the thaw that shows you where. Ice dams push water up under the shingles, spring snowmelt comes all at once, and summer hail can finish off what's left of an old roof.
Homes here are built tight against the cold, and that's good until water gets in. Then insulation and vapor barriers hold it inside the wall. A finished basement raises the stakes, and if you leave for the winter, it's worth turning off the water before you go.
Snowmelt is the big one. While the ground's frozen, none of it soaks in, so it runs toward low spots and window wells. On the plains, heavy clay holds it against the wall. In the mountains, rock does much the same.
In air this dry, the surface gives up water quickly and the core doesn't. That's why moisture meter readings go right into the framing and subfloor, and the equipment stays until those deep numbers come down.
When you call
We'll ask where you are, what happened and whether the water's still running. That takes a couple of minutes. Then we'll connect you with a specialist from our network who works in Lewis and Clark County, and you can ask them when they can be there before you hang up. Homes and commercial buildings are both fine.
Before any equipment goes in, the specialist needs to know two things: how far the water got, and how dirty it is. Thermal cameras and moisture meters answer the first. For the second, there are three answers: Category 1, clean water, Category 2, dirty water, or Category 3, sewage and floodwater. With Category 3, plastic containment goes up and negative air machines with HEPA filters keep your house's air clean.
Drying is a process, and you'll have strange machines in the house for a few days. The bulk of the water goes first, by truck-mounted or portable extractor. Air movers then lift moisture off surfaces, and low grain refrigerant (LGR) dehumidifiers remove it from the air. A cold building or dense material may need desiccant units instead. Daily psychrometric readings show if the air is still pulling water out.
So how do you know it's done? It's done when the numbers say so. A dry baseline from untouched materials in your house is the target, and each wet area has to reach it before the equipment leaves. It follows the IICRC S500 standard, and you get a record of the readings for your insurance claim.
More than you'd think, if it's caught early. Carpet soaked with clean water can often be dried in place once the pad's been pulled. Hardwood is worth trying to save too, with floor drying mats and slow drying, though it may need refinishing. Drywall that's wet only at the base can be cut a little above the waterline instead of being replaced to the ceiling, which is what a flood cut is.
Contaminated water is where the rules get strict. Sewage or floodwater means the carpet and pad come out, along with wet insulation, and what's left gets an antimicrobial treatment. It's also not safe to relight a gas appliance that's been underwater until someone's checked it, and a soft floor needs a look before anyone stands on it.
Calls come to us from homeowners, landlords and business owners across Helena Valley Northeast and Lewis and Clark County. Give us your address, and we'll find out who's closest.
Usually the same day, and often within a few hours. It depends on who's closest and how busy Lewis and Clark County is. If a storm has just gone through, everyone's calling at once, so call as soon as you can.
Small and clean, yes. Large or dirty, no. A shop vac and fans can deal with a little water on a hard surface, but they won't reach what's soaked into drywall and subfloor. That hidden moisture is where mold and rot get started.
It depends on how much got wet and for how long. A fresh leak in one room could be dry in a couple of days, while a soaked floor and walls may need a week. You'll see daily readings, so you'll know how it's going.
It depends on time and on the water. For hardwood, floor drying panels and patience can do a lot, though refinishing may still be needed. For carpet, clean water usually means new pad and the same carpet. Contaminated water means replacing both.
Sudden and accidental damage, such as a pipe that bursts, is usually covered. Slow leaks and rising floodwater usually aren't, unless you've got flood insurance. Take pictures before cleaning up and keep every receipt, because your insurance company will ask.
The sooner drying starts, the less has to come out. One call gets a local specialist moving toward you.